Summary

This retro space ship comes in three variations, all with a main thruster supplemented by three attitude jets.

Instructions

For speed, this was printed at 0.3mm in about an hour. The design permits printing without raft or supports. If the reach is aggressive for your printer you can either use supports or go for a cooler print by slowing the speed and lowering the temperature.

The bottom surface is sized for 0.4mm nozzles, reducing the size is not recommended unless finer printing is possible.

Caution should be used in removing the model from the build plate: the connecting legs are fairly weak. Just a little twist is required to detach each attitude jet. The main body can then be removed.

Retro Spaceship