Summary

It is a small-size funfair big wheel.

Clara Gómez

Instructions

Some of the models have to be printed several times. In the following, I tell the number of prints for each one

ejes: once (the base was just used as support material because of the printer).
noria2_techo: it is the ceiling of each of the cabins. The maximum is 12, in my case I printed 6.
noria2_base: it is the base of each cabin (the same as for the ceilings).
noriaEjesCentro: it is the center of the wheel, where all the radii are assembled. You should print two.
radios: each of them is a radius, with the corresponding section of the wheel. You should print 12 for each wheel, so 24.
noriaPie1 and noriaPie2: these are the base of the big wheel. You should print one of each.
soporte1 and soporte2: these pieces form the support of the wheel. You should print two of soporte1 and four of soporte2.

big wheel - noria