Summary

Drum bracket for electronic drum kit 'Session Pro' and other name badges

Instructions

OK, I know this is a bit specialised, but if you have one of these kits you will know the brackets break.
This thing was printed in PLA, but I suspect ABS will be stronger. PLA works fine though. I printed using 210 degree extruder and a 60 degree blue tape covered bed, 10% fill, rafts off and supports on at 0.2 . A little bit of fettling to the slots in the 'V' groove was needed, the 2 screw pilot holes needed drilling out (2 mm drill - I did by hand with a hex shaft bit in a hex handle). The main bolt hole was drilled out with a 6mm drill the same way. The bolt hole in the original part is offset. it is straight through in my thing. As bolts tend to be straight, I thought a straight hole would be better and would not put as much (needless?) strain on the bracket.
I have included a SketchUp v15 file.
I'm off for a beer and a para-diddle.
Cheers!