Summary

This is version 2 of the GoPro HERO3 mount to suit 450PRO helicopters. Ensures a slight downward angle of the lens in hover. Allows for use of velcro to secure camera. Now allows user to glue camera part to mount part on an angle to ensure camera is level during hover.

Instructions

Print part 'B' with velcro tabs pointing "UP", raft to prevent warping, 0.2mm layer height, 0.99 scale
Print part 'A' with zip-tie holes vertical. Raft to prevent warping, 0.2mm layer height, 0.99 scale
On part 'A', use double sided tape under the two "feet", then strap down hard with zip ties through holes onto battery tray.
Using superglue or similar, glue part 'B' to part 'A' at an angle of ~3 degrees of leftward tilt. This is to counteract hover tilt on 450 helis
Ensure you always secure your camera with velcro by using the designated tabs

NOTE: Ensure your glue will hold your expensive camera well enough. Also be careful getting the correct angle of tilt - if you get it right it makes a world of difference to your footage :)

Ver.2 GoPro HERO3 mount to suit 450 helis