Summary

A method of determining optimum print temperature for your filament.

Now with 0.5 mm Tip, 1.75 mm filament & 0.25 mm Layers

Instructions

Use slicer with your normal settings, to build G-CODE,
Remember to start at a relativity high temperature,

Using Notepad++, or TextPad,
scan through and look for G1 .... X....
at each 5 or 10 mm 'whole number'

assuming you print at 0.25 mm for example,

and add:
M104 S175

for example will set temperature to 175 Deg. C.

I will attempt to post a modified file later.

USAGE:

Print, and carefully watch for when your filament stops bonding,
or even worse stops extruding.

WARNING YOU MUST STOP PRINTING AT THIS POINT !!!!!

You can now decode the BINARY BLOCKS, and determine optimum temperature for each filament you own.

Enjoy

Ceri