Spektrum Module Case for Taranis

I had a hard time printing the body part with the sprint to hold it in place, so I remixed it a little bit by removing the spring part and just adding two little blocks that are pushed to the side and hold the module in place.
These blocks are secured with a screw eacht that comes from the DX5 I took apart to get the RF Module.
The little screws that hold the lid on top are from the DX5 also.
And i modified the lid so i get straight edges that fit on the modified body...
The inside of the box is also a little cleaner beacuse i am going to put a self addhesive copper foil on the inside to shield the module and prevent interference with the radio