Power switch for 10mm rods

This is a box for mounting a Home Depot power switch on the Y axis 10mm rods.

The switch is a Servalite TA201U rocker switch, SPST.

Mounts are borrowed from--
http://www.thingiverse.com/thing:335726

Make sure to solder the wires before snapping the switch into place. The box doesn't open for access inside.

Print with supports or the mounting clips will fail. I used overhang supports generated by Meshmixer.

Note: The photos show the C clips in the wrong position. They have been moved down in the STL file to the other edge of the box so the box doesn't lift the bed up.