Night Visionaire - Servo connector holder for wing

The Night Visionaire from E-Flite takes a lot of fiddling with servo wires when removing or attaching the wings. This thing makes it soo much easier.
Just glue the 2 connectors from the wing into this holder. Make sure most of the plug still sticks out and that they stick out straight. Glue this assembly into the wing making sure its flush with the wing.
Add a longer Y cable in the fuselage and 2 servo extension leads for the lights. Attach the sockets of these to the corresponding plugs that now stick out of the wing. Note orientation. Remove them and glue them on top of each other in the correct order and orientation. Attach them back onto the wing and put some glue on the outside of the sockets. Place the wingtube, slide the wing over it and press the wing firmly to the fuselage. That should press the sockets into the fuselage and line them up perfectly. Allow the glue to dry and remove the wing. All done!

P.S. be carefull not to use too much glue or you risk glueing the wing on permantly.