Summary

New version is now available. v2.0 of the raven.
Goto http://www.thingiverse.com/thing:962361

A 3D Printed Quad Copter by Bad-Intel and Cyberpunk V2.0 . http://www.cyber-punk.info

It is a design that was built for testing flight duration and with a 4S 6000mah battery. Gives me about 50 mins flying time.

Have done test flights and all works rather well.

Instructions

All parts are attached together with aluminum square tube. http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=40657

The 3D printed parts should slot into the aluminum square tube.

Requires drilling, nuts and bolts to put it all together. The holes to be drilled are already part of the 3D print and just need to be drilled out to size.

I use two body plates to extend the length of the copter. But for smaller copters, just use one body plate.

The front has a hole for a CCD camera, while the back has a hole for a antenna to fit.

The unit in the photo uses 4x MT2213-935KV MultiStar Motors with a 4S 6000mah battery. (Gives me about 60 mins flying time)

Will publish the canopy and all terrain landing gear soon.

For personal use only.
Copyright of http://www.bad-intel.com and http://www.cyber-punk.com

Raven Version 1 Quad-Copter