Summary

This is a spool holder designed to allow the use of a 28mm spool on the Replicator 5th Generation. It is compatible with larger diameter spools as well.

Instructions

Print 1 of each of the files.

We use about 25% infill for the Bracket and 50% for the Spindle.
The pins may require printing at a higher resolution, but the bracket and spindle print fine at .3mm.

To get a snug fit you may have to apply a couple pieces of tape to the spool holder as a spacer. This prints slightly larger than necessary to allow easier installation/removal.

Reuse of the stock guide tube is possible, the way the guide tube is held in the printer pinches the tube slightly so you may slightly damage your guide tube if not removed carefully.

Replicator 5th Generation 28mm Spool Holder