Wire spool

Basic spool to keep your assorted lengths of wires.

Update:

• separate parts
• slightly thicker parts
• little hole in the tube to hold the wire
• small gap in the spool to catch the end
• added a spool axle holder, just cut a 5/8th PVC electrical tube to length. I’ve added a hole so you can screw it down if the tolerances don’t match up with your printer. Also there are a few mounting screws for screwing to a wall or baseplate (screw go on the outside, bolts on the inside)

Because of the tolerances of the print, assembly may need a little sanding before it fits tightly.

The v3 file fixes an error where not all objects where aligned vertically.