Summary

Mount for QUBD twoUP. Mounts e3d lite6 to a nema 17 footprint.

Instructions

-I used in conjunction with a downloaded bearing/extruder mount

-Requires 2x 3mm or 4-40 screws. Length unknown, I used 50mm m3 screws and trimmed to length.
-Holes slightly undersized for screws to bite into plastic.
-Do not over tighten.
-will need to re-tighten clamp after a couple prints, should be fine after.

My printer is printing on a piece of 1/8" glass. If you are on the original bed the hot end may or may not reach the bed without modification.

QUBD twoUP bowden e3d lite6 hotend mount