Summary

A second go at modeling a 180mm quadcopter frame. This one includes a flight controller vibration isolation platform and upper deck. Modeled for a standard 30mm edgewise flight controller and 12mm crosswise motor mounts.

Instructions

I printed this with Hatchbox ABS with 75% infill.

I used a Flip32+ flight controller, a ReadyToFlyQuads 4-in-1 ESC, DYS 1306 3100KV motors, Gemfan 4045 props, an OrangeRC 3Ch (+ 12 S.Bus) receiver and a Spektrum Ultra Micro FPV camera.

For the upper deck I used four 30mm nylon standoffs. For the FMU platform I used 6mm rubber spacers. (6mm diameter hole in the platform and upper deck that is) For the ESC and FMU I used nylon M3 screws and nuts, with some M3 o-rings for spacers. For everything else I made extensive use of velcro tape and zip ties to get everything on it.

It can handle 3s 1000mah batteries without much issue but for indoors 2s batteries make for easier flying.

Super Simple 180MM Quadcopter Frame V2