Summary

A 3D Printed Quad Copter by Bad-Intel and Cyberpunk V2.0 .
This Is version 2.0 of the quadcopter.

From: http://www.cyber-punk.info

Improvements:
Stronger Motor and Landing mount.
Reinforced canopy covers

https://www.youtube.com/watch?v=ra6kpXIz6wo

Instructions

All parts are attached together with aluminum square tube.

The 3D printed parts should slot into the aluminum square tube.

Requires drilling, nuts and bolts to put it all together. The holes to be drilled are already part of the 3D print and just need to be drilled out to size.

I use two body plates to extend the length of the copter. But for smaller copters, just use one body plate.

The front has a hole for a CCD camera, while the back has a hole for a antenna to fit.

The unit in the photo uses 4x MT2213-935KV MultiStar Motors with a 4S 6000mah battery. (Gives me about 45 mins flying time)

Will publish the canopy and all terrain landing gear soon.

For personal use only.
Copyright of http://www.bad-intel.com and http://www.cyber-punk.com

Parts List:
Q Brain 4 x 20A Brushless Quadcopter ESC 2-4S 3A SBEC http://www.hobbyking.com/hobbyking/store/__36674__Q_Brain_4_x_20A_Brushless_Quadcopter_ESC_2_4S_3A_SBEC.html

MT2213-935KV MultiStar Motor and Propeller Combo 10x4.5 CW/CCW http://www.hobbyking.com/hobbyking/store/__43884__MT2213_935KV_MultiStar_Motor_and_Propeller_Combo_10x4_5_CW_CCW.html

Multistar High Capacity 4S 6600mAh Multi-Rotor Lipo Pack http://www.hobbyking.com/hobbyking/store/__56848__Multistar_High_Capacity_4S_6600mAh_Multi_Rotor_Lipo_Pack.html

Multiwii and Megapirate AIO Flight Controller w/FTDI (ATmega 2560) V2.0 http://www.hobbyking.com/hobbyking/store/__31138__Multiwii_and_Megapirate_AIO_Flight_Controller_w_FTDI_ATmega_2560_V2_0.html

Aluminum Square Tube DIY Multi-Rotor 12.8x12.8x600mm (.5Inch) http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=40657

Raven Version 2 Quad-Copter