Summary

This is another slight variation of the original.

Instructions

Printed on a MakerBot Replicator V2 using PLA. Print with the inside surface flat on the bed (the surface that would be touching your skin). Printed using a medium setting. This is the USB that I used:

http://www.ebay.com.au/itm/Kingston-8GB-8G-DataTraveler-DT-Micro-USB-Flash-Pen-Drive-Memory-Stick-Key-Thumb-/271135622472?pt=AU_USB_Flash_Drives&hash=item3f20f14548&_uhb=1

Simply remove the original casing and place inside the bracelet. Press fit, no glue required.

USB Bracelet variation 2