BabyNES case modified

This is the BabyNES case:

http://www.thingiverse.com/thing:449877

But with a few modifications I'm working on.

The top lid is the vented variant, but with the cutout for the Raspberry Pi camera cable. It also has larger standoffs as the small ones may cause problems for people, and are really unnecessarily weak.

v2 of the top part has the thickened standoffs, but backed off from the edges by 0.1mm just in case of overextrusion.

The base has a few changes:

1. Reduced the standoff size as they were hitting solder joints and components, preventing the Pi from seating correctly
2. Removed the power buttons. They just don't look good when printed this way; I would rather print them separately and glue them or something.

The replacement cart lid is about 0.5mm longer than the original. Original seemed to come up short.