Summary

Enclosure to serve as base for Raspberry 2 trail camera with PIR and IR LED cutouts

Instructions

Use PIR sensor like so
https://learn.adafruit.com/pir-passive-infrared-proximity-motion-sensor/overview
Position the sensor and then drill the holes to fit those on the IC board of the PIR.

The bona fide Pi NoIR camera like so
https://www.raspberrypi.org/products/pi-noir-camera/
Position the camera and then drill the holes to fit those on the IC board of the camera.

IR LEDs on normal perfboard (skip 'n column between LEDs then the spacing will be fine). I use 5mm LEDs. Needed to drill holes after print to widen them further with 5.5mm drill.

The Autodesk 123D file is also uploaded so you can patch up the holes if not needed but they're supposed to allow for external power and ethernet if the trail happens to be in your home.

Use printer with heated bed only as everything needs to print perfectly flat if you want it to close tight.

Raspberry Trail Cam