Summary

Here is a a sensor mount that will allow you to mount the new FTC sensor on the side of channel only using up one flower pattern.

Printed on Wanhao Duplicator i3

Built by Daniel from FTC team 8372 Trial N' Terror Medford Oregon out of Saint Mary's High school

Print Settings

Rafts:

No

                                            <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>200 microns</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>25-30%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Because this isn't a part that takes a load 25-30% infill is sufficient </p></div>

Instructions

Print at 200 microns, square infill at 30%

place the side with all the main flower pattern down on the print pad and print with no supports

Then mount your sensor and bracket to the channel, enjoy!

FTC Modern robotics V3 L bracket sensor mount